A center punch is used to mark the center of a point.
It is usually used to mark the center of a hole when drilling holes.
Warning: Always use punches and chisels on materials softer than the hardness of the punch itself.
Warning: Always wear safety goggles
| Cut | Shank | Length | P/N |
|---|---|---|---|
| 5/32" | 5/16" | 4-1/2" | T4871 |
| 3/16" | 3/8" | 5" | T4872 |
| 5/16" | 1/2" | 6" | T4873 |
Made of the highest grade carbon steel, accurately hardened and tempered preventing splintering and extending life
Edges accurately tempered to stay sharp
Working ends accurately ground and hardened to HRC 52-58 for maximum service
Striking end hardened to HRC-42 maximum – won’t chip or mushroom
A center punch is used to mark the center of a point.
WARNING: Always wear safety goggles
Working ends accurately ground and hardened to HRC 52-58
Striking end hardened to HRC-42 maximum